|NEWS & FAQ Jakansonic Ultrasonic Cleaner >NEWS & FAQ>Troubleshooting |
Troubleshooting for ultasonic cleaner:
If your ultrasonic cleaner got some trouble like the table showing below you can follow this table we suggest to find the solutions
|The cleaner is not working||1.Cleaner not plugged in properly. |
2.Mechanical timer is OFF
3.POWER switch is OFF.
4.Start button malfunctioning.
|1.Plug into functioning electrical |
2.Turn on the timer.
3.Press power switch ON.
if 4 and 5 ,you should call the service center.
| Cleaner operates but does |
not heat solution
| 1.Heater is off or is not set |
2.Heater malfunctions or membranemalfunctioning.
|1. Turn on the heater. |
2.you should call the service center.
| Clogged drain |
|1. waster solution clogged the drain||1.call the service center|
| Cleaner operates but does notmaintain set temperature |
|1.Malfunctioning heater orsensor components.||1.call the service center|
| Cleaner operates butdisplay does not function. |
|1.timer board malfunctioning.||1.call the service center|
|Decreased ultrasonic activity.||1.Solution is not degassed. |
2.Solution is spent.
3.Solution level is incorrect
4.Tank bottom is covered
|1.Make sure that tank was filled with warm tap water plus cleaning solution and has run 5-10 minutes. |
3.Adjust solution to within 3/8 inch of the tank’s operating level line with load.